Oracle Cloud Infrastructure Documentation

Remove the Ruggedized Case End-Caps

If the Roving Edge Device is in a ruggedized case, you must remove the front and rear end-caps to access the cable connectors. The end-caps remain removed during operation.

Caution

Don't remove the Roving Edge Device from the case. Doing so can damage the device.
Caution

Leave the end-caps removed during operation to ensure adequate airflow. Reinstall the end-caps only when the device is powered down.

  1. On the front and rear of the ruggedized case, find the 16 wing-turn latches.

    Note: The rear end-cap has casters.


    An illustration showing the front and rear of the ruggedized case where the wing-turn latches are located.

  2. Open all 16 wing-turn latches on the front and rear of the case by lifting the latch then turning the latch counterclockwise.

    An illustration showing how the latches open.

  3. Remove the front and rear end-caps.


    An illustration showing the end-cap removal.

  4. Remove the cable pouch, and extend the end-cap hooks.


    An illustration showing the end-cap hooks that are used to store end-caps on the side of the case.
  5. Hang the end-caps on the sides of the ruggedized case.
    An illustration of the end-caps hanging on each side of the case.

What's next?

Cable the Roving Edge Device