1. Navigate to the resource page for the DR Protection Group.
2. In the Resources panel on the left, click the Members link to navigate to the Members section for the DR Protection Group.

Remove a Single Member

1. Click the three-dots Action menu selector on the right of a member and select Remove.
2. Accept the warning that any existing DR Plans will require you to refresh and verify them.
3. Click Remove to remove the member from the DR Protection Group.

Remove multiple members

1. Select the members that you want to remove by clicking the box to the left of each member.
2. After all members are selected, click Remove members at the top of the table.
3. Accept the warning that any existing DR Plans will require you to refresh and verify them.
4. Click Remove to remove all the selected members from the DR Protection Group.
   Note
   
   

   You must refresh and verify all the existing DR plans.

   To understand how plans are refreshed and verified see the following topics:

   • Refresh a Disaster Recovery Plan
   • Verify a Disaster Recovery Plan