You can modify a Disaster Recovery (DR) plan to rename a DR plan, edit plan group attributes, and edit attributes of steps in a plan group.

Full Stack DR creates out-of-the-box DR plans by performing intelligent introspection on the members in the primary and standby DR protection groups. These out-of-the-box DR plans contain groups and steps that are called built-in. Once a built-in DR plan is generated, you can modify the plan to add your own groups and steps called user-defined groups and steps. In addition to adding user-defined groups and steps to a plan, you can also modify the execution attributes of built-in groups and steps.

• Rename a Disaster Recovery Plan
  You can rename a Disaster Recovery (DR) plan to assign a new name to an existing plan.
• Edit Attributes of a Plan Group
  You can edit attributes of a Disaster Recovery (DR) plan to rename the plan group, enable or disable steps, and change timeouts.
• Edit Attributes of Steps in a Plan Group
  You can edit attributes of steps in a Disaster Recovery (DR) plan group to change the step name, error mode, timeout, and enable or disable the step.
• Add a Pause Group in a Plan Group
  You can add a pause group in the list of plan groups to pause the plan executions.
• Change the Order of Execution of Plan Groups
  Modify the order in which you run Disaster Recovery (DR) plan groups.
• Add User-Defined Plan Groups and Steps
  You can add user-defined groups and steps to a Disaster Recovery (DR) plan after Full Stack DR creates an initial DR plan with built-in groups and steps.
• Remove User-Defined Plan Groups
  You can remove a user-defined plan group in a Disaster Recovery (DR) plan.
• Remove User-Defined Steps From a Plan Group
  You can remove user-defined steps from a plan group in a Disaster Recovery (DR) plan.